✔ New LED technology anti-collision lights.
✔ When the door is turned on, it flashes rapidly, warning the rear to avoid the accident occurred.
✔ First 6 seconds “rapid flash” mode, best warning to the rear of the car. After 110 seconds of lighting, it will be off automatically.
✔ Then the red cover still can be used to reflect light to remind the rear.
✔ Waterproof cap and build in high-tech component sensor, long service life.
✔ Powered by button battery, easy to replace by yourself.
✔ DESTELLO CAR LED DOOR LIGHTS✔UNIVERSAL DESIGN:
No Extra Battery Wirings Required, Enhances Your Car Looks. 3V Cr2 Batteries Freely Provided With Products. car door open light Fit for any cars, SUV, truck. Wireless design, wireless car door warning light do not destroy the original car lines, only need to stick them at the door, car led light.
✔WIRELESS & POWER:-
wireless car door warning light No need to cut and wires, easy to install by sticking on the door with the self-gum; with a CR2032 battery, screw cap for easy replacement of battery .car led light
✔3 MODES FLASHING:-
0-7 Seconds: All Led Rapid Flashing. 7-60 Seconds: Each Led Sequential Flashing. 60-110 seconds: Each Led Slow Swirl Flashing. Automatic power off after 110 seconds..car interior lights led car indicator led light.✔WATERPROOF DESIGN: car led light Soaked in water for 30 minutes, still can work. High-tech component sensing: through the IR chip program control, increase the sensitivity, to maintain the stability of the product. car door led lights car door warning lights.
✔LONG BATTERY LIFE:
you have to keep the battery in green circuit board* ar door flashlight The product is the use of CR2032 button battery (The Battery is Included), through testing, at normal operating condition, you can use 1-1.5 years, screw cap design, can replace the battery easily car magnetic light .car light accessories.
✔EASY INSTALLATION PROCESS
The process of installing The Warning lights is not of a great deal of the work of an expert. The following simple steps can be followed to install them:
1. The surface where the LED lights are to be stuck needs to be cleaned properly.
2. Tear off the double-sided tape and test the position first.
3. Stick the light on the car door where the tape is applied.
4. On the adjacent opposite side that is on the car interior you are required to place the magnet using the other piece of 3M double-sided tape.
5. Once you are done with sticking of the light and the magnet, you need to to check the working.
6. Finally, the process is completed.
Important note:- While you receive the product make sure to insert the battery’s in green circuits board, then only it will start.